Belt Changing; To Remove Belt; To Replace Belt - Kenmore 116.29219 Use & Care Manual

Always follow all safety precautions when performing maintenance on the PowerMate.
WARNING
Electrkal Shock Or Personal injury Hazard.
Always turn off and unplug vacuum cleaner before performing maintenance to the
vacuum cleaner. Fallure to do so could result in electrical shock or personal injury from
vacuum cleaner suddenly starting.
BELT CHANGING AND AGITATOR CLEANING
TO REMOVE BELT
1. Turn PowerMate
upside down.
2. Unscrew two (2)
PowerMate cover
screws.
3. Turn PowerMate _• ---_-_
right side up. Press _ __,_
handle release __._?
pedal and lower ?_
the swivel. Lift
rear and side
latches up.
Side ear
Latch Latches
4. To remove
cover, grasp the
sides and pull out.
5. Lift agitator
assembly out
and remove
worn belt.
6. Check and clean end cap areas. See TO
CLEAN AGITATOR section and AGITATOR
ASSEMBLY illustration for picture of
complete agitator assembly.
=17=
TO REPLACE BELT
1. Install new
belt over
motor drive,
then over
belt path.
r
e
Agitator End Cap
NOTE: See PARTS
AND FEATURES
for Belt number.
2. Place agitator
assembly back
into PowerMate.
3. Lineup front
of cover and
base. Rest
cover on front
edge of base as
shown.
T
Cover
Base
4. Rotate cover
back. Press cover
firmly until side
and rear latches
snap into place.
;ide Rear
Latch Latches
Make sure there is no gap between the
cover and base.
5. Turn PowerMate upside down and re-
place two (2) cover screws.