Kenmore 116.29219 Use & Care Manual page 10

6.To turn vacuum
cleaner on, s tep on
the
ON/OFF switch.
t \ .............. :::\1
7. To turn on
PowerMate, move
the
FLOOR/CARPET
switch to the
CARPET position.
NOTE - When this switch is in the FLOOR
position, the headlight DOES NOT function
since no electricity flows to the PowerMate.
Attention: Refer to your carpet manufactur-
ers cleaning recommendations. Some more
delicate carpets may require that they be
vacuumed with the PowerMate agitator
turned off, to prevent carpet damage.
CAUTION
DO NOT leave the PowerMate running in
one spot in the upright position for any
length of time. Damage to carpet may
occur.
VACUUMING TIPS
WARNING
Personal Injury and Product Damage
Hazard
DO NOT run over power cord with
PowerMafe. Personal injury or product
damage could result.
DO NOT pull plug from wall by
the power cord. if there is damage to
the cord or plug, personal injury or
property damage could result.
CAUTION
Product Damage Hazard
Use care if the PowerMate and wand is
left in the upright position as it may tip
over easily. Property damage can occur if
tipped.
Suggested sweeping pattern.
For best cleaning action, the PowerMate
should be pushed straight away from you
and pulled straight back. At the end of each
pull stroke, the direction of the PowerMate
should be changed to point into the next
section to be cleaned. This pattern should
be continued across the carpet with slow,
gliding motions.
NOTE: Fast, jerky strokes do not provide
complete cleaning.
The hose swivel allows the hose to turn with-
out moving the canister. This is helpful for
cleaning in small areas.
Check hose for
twisting before
pulling canister.
- 10 -