Kenmore 141.16671 Operator's Manual page 18

Grill
Lighting
Instructions
• Before each use, check all hoses for cracks, nicks,
cuts, burns or abrasions. If a hose is damaged in any
way, do not use grill before replacing hose with
identical part from Parts List. Also, make sure all gas
supply connections are securely tightened.
• Familiarize with the safety and Use and Care instruc-
tions in this manual. Do not smoke while lighting grill
or checking gas supply connections.
• Be sure the LP Gas tank is filled.
Side Burner Lighting Instructions
1. Follow steps 1 through 5 of the Grill Lighting
Instructions.
2. Open Side Burner Lid.
3. Set Control Knobs to OFF and open the LP Gas
tank valve SLOWLY 1/4 of a turn.
4. Push and turn the Control Knob to HIGH._
The built-in spark ignitor will light the Burner auto-
matically.
Failure to replace a faulty hose, secure gas supply
connections or to open the grill lid before proceed-
ing to light grill could result in a fire or explosion
that could cause serious injury, death, or property
damage.
To Light grill
1. Open the Grill Lid.
2. Set Control Knobs to OFF and open the LP Gas
Tank valve SLOWLY 1/4 of a turn.
m
OFF Open LP Gas tank
_J
tGN
3. Press the Power Button to turn on the Burner Indicator
Display.
Left Rear Right Rear
P°_ern_ _ _ _
Left Front Right Front
4. Push and turn desired burner Control Knob to IGN and
hold it in 3 - 5 seconds to ignite.
I
IGN
Low H_
OFF
5. Check Display to see if desired burner indicator lights
up in about 10 seconds. If indicator lights up, turn
Control Knob away from IGN to HIGH.
5. You may have to push and turn the Control Knob up
to 3 or 4 times to light.
6.
If ignition does not occur, turn gas off at source and
turn Control Knobs OFF. Wait at least 5 minutes for
gas to clear, then retry. If your grill still fails to light turn
the burner Control Knob and gas source OFF and
conduct a leak test of ALL gas connections and fuel
sources. If no leaks are detected, wait 5 minutes for
any gas to clear and repeat the lighting procedure.
Manually Lighting
Your Grill
By Paper
Match
To light your gas grill by match, insert a match into the
Lighting Stick and follow steps 1 through 6 of the Grill
Lighting instructions. Then, light the match and place
Lighting Stick through the Lighting Hole on the left side
of the grill as shown below. Turn the nearest Control
Knob to the HIGH setting to release gas. The Burner
should light immediately.
Lighting Hole
Lighting Stick
Match
6. If burner indicator does not light up in about 10
seconds, turn Control Knob and gas source OFF, wait
5 minutes for gas to clear, and repeat lighting proce-
dure.
7. Once desired burner is lit, light adjacent burners by
turning knobs to HIGH.
NOTE: If Burner indicator Display does not turn ON
after pressing Power Button, check battery housed
under Display casing.
18
Never lean over the grill cooking area while
lighting your gas grill. Keep your face and body
a safe distance (at least 18 inches) from the
Lighting Hole or Burners when lighting your grill
by match.