Kenmore 141.16671 Operator's Manual page 10

Install Tank Holder to Cart Bottom Shelf
[] Align the 4 holes (2 on either side) of the Tank Holder Bracket with the holes on the Cart
Bottom Shelf and insert 4 Phillips Head Screws 3/6" x 1/2" as shown.
[] Secure Cart Bottom from the underside using 4 Flange Nuts 3/16".
Note: When installing tank, remove Wing Bolt on Tank Holder to unclamp the 2 Arm Rims.
Place Holder over Tank, then reclamp the Arm Rims back together using Wing Bolt and
tighten securely.
[] install 4 Casters onto Caster Seats. Arm Rims
(
Wrench/No.17 Customized
Qty. 1
Part # P05515025L
Scale 1:2
©
Flange Nut 3/16"
Qty. 4
Part # $3!3G03061
Phillips Head Screw 3/16"xl/2"
Qty. 4
Part # $1!2G03081
I
I
I
I
I
I
I
I
@
H Install
Cart Rear Panel and Door Brackets
[] install the Cart Rear Panel between Rear Cart Legs as shown using 4 Phillips Head Screws
3/6" x 3/8"and 4 Flange Nuts 3/16".
[] install the Door Bracket in the up position between Front Cart Legs as shown.
[] install the Lower Door Hinge Brackets to Lower Cart Side Panels and tighten securely
securely.
Wing Bolt
Phillips Head Screw 3/16"x3/8"
Qty. 10
Part # $112G03061
J
.j..
J
J
Flange Nut 3/16"
Qty. 4
Part # $3!3G03061
j-
10