Kenmore 141.16671 Operator's Manual page 14

Install
Ignitor Battery
[] Unscrew Ignitor Cap from Control Panel.
[] Place supplied AA battery into the Ignitor
Slot with positive pole facing you.
[] Position the Cap and Spring over the AA
battery and tighten onto Control Panel.
Main Burners Electrode Check
Perform this Electrode Check with the
assistance of another person.
This test will ensure that the Spark Electrode Tips
are properly positioned so your grill lights easily
and properly.
AA Battery
\
Cap
Burner Ignitor
Display Lid Ignitor
Disptay
Spark Receiver Spark Eiectrode Tip
[] Be sure all Control Knobs are set to
"OFF" and open the Grill Lid.
[] Have your assistant stand behind to the
right of the grill and look toward the front
of the grill bowl. Never put your face
inside the Grill Bowl.
[] Press the Ignitor Cap. You should hear
a "clicking" sound. Your assistant should
see a blue spark within each Gas
Collector Box. If a spark is present the
Electrode Tips are properly positioned.
[] If no spark is seen, the Spark Gap
needs to be adjusted as follows:
• Using an adjustable wrench, loosen the
inside Nut until the Gas Collector Box can
be turned upward.
• If the gap between the Spark Elec-
trode Tip and Receiver is more than
3/16" use long nose pliers to gently
squeeze the Gas Collector Box to
narrow gap.
• Return the Gas Collector Box to its
original position, secure the inside Nut
and try the Electrode Check again. If no
"clicking" sound is heard:
• AA Battery may be installed back-
wards.
• Electric wires may be loose. Remove
the AA Battery and inspect the ignitor
Junction Box found behind the Control
Panel and reconnect any loose wires.
Side Burner Electrode Check
[] Open side burner lid. Remove plastic
shipping band from burner and pot
support.
[] Push and turn side burner Control Knob
to HIGH. Look for spark between tip of
electrode and burner.
[] If you don't see a spark from side burner elec-
trode, adjust gap between electrode and
burner surface to 3/16 in.
Install Burner Ignitor Display Battery
[] Remove lid casing under Burner Selector
Display box and install one 9V Battery.
Then replace the lid.
Install Cooking Components
[] Place Cooking Grids on bowl ledge.
[] Place the Secondary Cooking Rack into
the slots on Grill Bowl Side Panels.
Secondary Cooking
Cooking
for
Secondary
Cooking Rack
When you have finished assembling your
grill be sure that all screws are tightened
for safe operation of your grill.
Before each use of the grill, the Grease/Water
Tray should be filled approximately 1/2 full with
water and carefully fully seated under the grill
bowl.
CAUTION: The Grease/Water Tray should be in-
spected before each grill use to be sure there
is no excessive grease buildup. Clean the tray
regularly and as needed.
14