Troubleshooting Washer - Kenmore 27-1nch Wide - Extra Large Capacity Plus LAUNDRY CENTER Washer - Electric Dryer Use & Care Manual

The dryer light automatically turns on inside the dryer drum when
you open the door.
To change the drum light
1. Unplug laundry center or disconnect power.
2, Open the dryer door. Locate the light bulb cover on the back
wall of the dryer. Remove the screw located in the lower right
corner of the cover. Remove the cover.
3. Turn bulb counterclockwise, Replace the bulb only with a 1g-
watt appliance bulb. Replace the cover and secure with the
screw.
4, Plug in laundry center or reconnect power.
TROUBLESHOOTING
WASHER
First try the solutions suggested here and possibly avoid
the cost of a service call...
Washer won't fill, rinse or agitate
• Checkthe following:
Is the power cord plugged in or power connected?
Is the indicator on the Cycle Control knob properly lined up
with a cycle? Turn the Cycle Control knob to the right slightly
and pull to start.
Are the water inlet valve screens clogged?
Are both the hot and cold water faucets turned on?
Is the water inlet hose kinked?
Does the water level seem too low, or does the washer
appear to not fill completely?
The top of the agitator is much higher than the highest water
level. This creates a perception that the washer is not filling
completely. This is normal.
Washer stops
• Checkthe following:
Is the power cord plugged in or power connected?
Is the indicator on the Cycle Control knob properly lined up
with a cycle? Turn the Cycle Control knob to the right slightly
and pull to start.
Are the water inlet valve screens clogged?
Are both the hot and cold water faucets turned on?
Is the water inlet hose kinked?
Is there power at the plug or direct connection?
Check your electrical source or call an electrician.
Has a fuse blown or is the circuit breaker open?
If problem continues, call an electrician.
Are you using an extension cord?
Do not use an extension cord.
• Isthe washer overloaded?
Wash smaller loads.
Is the washer in a normal pause in the Permanent
Press cycle?
The washer pauses for about 2 minutes in the Permanent
Press cycle, Allow the cycle to continue,
Washer won't drain or spin
Is the drain hose clogged, or the end of the drain hose
more than 96 in. (2.4 m) above the floor?.
See "installation Instructions" for proper installation of drain
hose.
Is the lid open?
The lid must be closed during operation.
Is there excessive sudsing?
Always measure detergent. Follow manufacturer's directions.
If you have very soft water, you might need to use less
detergent.
Is your voltage low?
Check your electrical source or call an electrician. Do not use
an extension cord.
Washer continues to fill or drain, or the cycle seems
stuck
• Is the top of drain hose lower than the water level in
washer?
The top of the hose must be higher than the water level in the
washer for proper operation (see "Installation Instructions"),
• Does the drain hose fit too tightly in the standpipe, or is it
taped to the standpipe?
The drain hose should be loose yet fit securely, Do not seal
the drain hose with tape, The hose needs an air gap (see
"Installation Instructions").
Washer makes noise
• Is the load balanced and the laundry center level?
The wash load should be balanced and not overloaded.
The laundry center must be level. The front feet should be
properly installed and the nuts tightened. Reset the rear
leveling legs (if needed), See "Installation Instructions."
Did you completely remove the yellow shipping strap with
cotter pins?
See "installation Instructions."
• Gears are engaging after the drain and before spin.
These are normal washer noises.
27