Table of Contents
Advertisement
11. Connect your computer and devices to electrical outlets, and turn them on.
Clearing CMOS Settings
CAUTION:
Before you begin any of the procedures in this section, follow the safety instructions in the Product Information Guide.
1. Follow the procedures in
"Before You
2. Remove the
computer
cover.
3. Remove the
hard drive.
4. Reset the current CMOS settings:
a. Locate the 3-pin CMOS jumper (RTCRST) on the
b. Remove the jumper plug from pins 2 and 3.
c. Place the jumper plug on pins 1 and 2 and wait approximately 5 seconds.
d. Replace the jumper plug on pins 2 and 3.
5. Replace the
hard
drive.
6. Replace the computer cover.
NOTICE:
To connect a network cable, first plug the cable into the network port or device and then plug it into the computer.
7. Connect your computer and devices to electrical outlets, and turn them on.
Back to Contents Page
Begin."
system
board.
Advertisement
Table of Contents
