Table of Contents
Advertisement
1 heat-sink assembly
CAUTION:
The heat-sink assembly can get very hot during normal operation. Be sure that the assembly has had sufficient time to cool before you
touch it.
4. Remove the two screws from either side of the heat-sink assembly.
NOTICE:
After you remove the heat-sink assembly, lay the assembly on its side. Do not set the heat-sink assembly upright or touch the thermal
interface to avoid damage to the thermal interface material on the underside.
5. Pivot the assembly toward the back of the computer and lift to remove.
Fan Assembly
CAUTION:
Before you begin any of the procedures in this section, follow the safety instructions in the Product Information Guide.
1. Follow the procedures in
"Before You
2. Remove the
computer
cover.
3. Remove the
CD/DVD
drive, if installed.
CAUTION:
The heat-sink assembly can get very hot during normal operation. Be sure that the assembly has had sufficient time to cool before you
touch it.
4. Remove the
heat-sink
assembly.
5. Disconnect the fan power cable from the FAN connector on the system board.
1 fan assembly
2 fan cable connector
3 fan release tab
Begin."
Advertisement
Table of Contents
