Hints For Timer Recording - Magnavox MWR10D6 Owner's Manual

Hints for Timer Recording

• If there is a power failure or this unit has been unplugged for more than 30 seconds, the clock setting and
all timer programming will be lost.
• If a disc is not on the tray, TIMER REC indicator flashes and Timer Recording cannot be performed. In
some cases, TIMER REC indicator will be on momentarily around the start point as the unit attempts to
record. Please insert a recordable disc.
• When all the Timer Recording is completed, TIMER REC indicator flashes. To play or eject the recorded disc,
press [STANDBY-ON
• During Timer Recording or timer standby mode (TIMER REC indicator will be on), any operations on the
unit will not be available. To make these operations available, cancel the Timer Recording or timer standby
mode first (TIMER REC indicator will be off).
• To cancel the timer standby mode, press [STANDBY-ON
• When the Start and the End time are the same, the length of the recording will be set for 24 hours. When
the disc reaches at the end during the recording, the unit turns itself off.
• When the programmed Start and End time are earlier than the current time, the setting will not be accepted
and be cleared for redoing.
• If the Start time is earlier and the End time is later than the current time, the recording will start right after
you turn the power off.
The priority of overlapped settings
This unit records the programs according to priority if the timer programmings are overlapped. The timer
programming set previously has priority.
A Timer Recording of lower priority will be canceled, start from the middle or stop on the way.
Check the overlapped timer programmings and change the priority if necessary.
A programming set previously has priority
When the starting time is the same:
A program set previously (PROG. A) has priority.
PROG. A
PROG. B
Actual
PROG. A
recording
The first 30 seconds (at the longest) will be cut off.
When the recording time is partially overlapped:
PROG. A will start after PROG. B is complete to
be recorded.
PROG. A
PROG. B
Actual
PROG.B
recording
The first 30 seconds (at the longest) will be cut off.
Note for DVD recording
• When the recording time of two programs
are overlapped, or the End time of a
program and the Start time of another
program is the same, the first 30 seconds
(at the longest) of the subsequent program
will be cut off.
• If the cut-off portion comes up to one
minute or more, this program will be
displayed with error number E40 in the
timer programming list.
Recording
Timer Recording (cont'd)
] first, then select the recorded title and press [PLAY B] or [OPEN/CLOSE A].
PROG. B
PROG.A
].
When some programming have been made at
the end time of the programming currently
being recorded:
A program set previously (PROG. B) has priority.
PROG. A
PROG. B
PROG. C
Actual
PROG. A
recording
The first 30 seconds (at the longest) will be cut off.
When the recording time is entirely overlapped:
PROG.A will not be recorded.
PROG. A
PROG. B
Actual
recording
When the End time of the programming
currently being recorded and the Start time
of the subsequent program are same:
If PROG. A is a DVD recording program, the
beginning of the PROG. B may be cut off.
PROG. A
PROG. B
Actual
PROG. A
recording
The first 30 seconds (at the longest) will be cut off.
PROG. B
PROG. B
PROG. B
EN 31