6. Connect your computer and devices to electrical outlets, and then turn them on.
Removing the Optional Hard Drive Fan
1. Follow the procedures in
Before You
2. Remove the computer cover (see
3. Remove all installed memory modules (see
4. Disconnect the fan cable from the FAN_HDD connector on the system board (see
5. Press the release latch on the hard drive fan and slide it out from between the hard drive bays, then lift it from the computer.
1
hard-drive fan release latch
Installing the Optional Hard Drive Fan
1. Slide the fan between the hard drive bays until it snaps into place.
2. Connect the fan cable to the FAN_HDD connector on the system board (see
3. Replace the computer cover (see
NOTICE:
To connect a network cable, first plug the cable into the network port or device and then plug it into your computer.
4. Connect your computer and devices to electrical outlets, and then turn them on.
System Board
CAUTION:
Before you begin any of the procedures in this section, follow the safety instructions in the Product Information Guide
Removing the System Board
NOTICE:
The system board and metal tray are connected and are removed as one piece.
1. Follow the procedures in
Before You
Begin.
Removing the Computer
Cover).
Removing
Memory).
2
hard drive fan
Replacing the Computer
Cover).
Begin.
System Board
Components).
System Board
Components).