Modem Connector - Dell Vostro 1700 Service Manual

3. Remove the hard drive (see
4. Remove the hinge cover (see
5. Remove the keyboard (see
6. Remove the display assembly (see
7. Remove the internal card with Bluetooth wireless technology, if installed (see
8. Remove the palm rest (see
NOTICE: Do not disconnect the CIR cable from the system board.
9. Disconnect the USB cable from the USB connector board.
10. Remove the two M2.5 x 5-mm screws that secure the USB connnector board to the base of the computer.
11. Lift the USB connector board out of the computer.
Replacing the USB Connector Board
CAUTION: Before you begin the following procedure, follow the safety instructions in the Product Information Guide.
1. Align the screw holes in the USB connector board with the screw holes in the base of the computer, and then lower the board into place.
2. Replace the two M2.5 x 5-mm screws and secure the USB connector board to the base of the computer.
3. Connect the USB cable to the USB connector board.
4. Replace the palm rest (see
5. Replace the internal card with Bluetooth wireless technology, if installed (see
6. Replace the display assembly (see
7. Replace the keyboard (see
8. Replace the hinge cover (see
9. Replace the hard drive (see
10. Replace the optical drive (see
Modem Connector
Removing a Hard Drive).
Removing the Hinge Cover).
Removing the Keyboard).
Removing the Display Assembly).
Removing the Palm Rest).
Replacing the Palm Rest).
Replacing the Display Assembly).
Replacing the Keyboard).
Replacing the Hinge Cover).
Replacing a Hard Drive).
Replacing the Optical Drive).
Removing the Bluetooth Card).
Replacing the Bluetooth Card).