Replacing The System Board Assembly - Dell Vostro 1510 Service Manual

Replacing the System Board Assembly
CAUTION: Before you begin the following procedure, follow the safety instructions that shipped with your computer.
NOTICE: Ensure that any loose cables do not get caught beneath the system board.
This procedure assumes that you have completed the removal procedure
1. Insert the left side of the system board into the base of the computer at an angle until the connectors on the system board are aligned with the holes
on the base of the computer, then carefully lower the system board into place.
2. Replace the three M2.5 x 5-mm screws on the system board.
3. Connect the 1394/USB daughter-card cable to the connector on the system board.
4. Replace the optical drive (see
5. Replace the palm rest (see
6. Replace the display assembly (see
7. Replace the keyboard (see
8. Replace the hinge cover (see
9. Replace the fan (see Replacing the
10. Replace the WLAN card (see
11. Replace the hard drive (see
12. Replace any blanks you removed from the ExpressCard slot and the 8-in-1 card slot.
NOTICE: Before turning on the computer, replace all screws and ensure that no stray screws remain inside the computer. Failure to do so may
result in damage to the computer.
13. Turn on the computer.
NOTE: If you use a BIOS update program media to flash the BIOS, press <F12> before inserting the media in order to set the computer to boot from the
media for one time only. Otherwise, you must enter the system setup program to change the default boot order.
14. Flash update the BIOS (see
15. Enter the system setup program to update the BIOS on the new system board with the computer Service Tag. For information on the system setup
program, see the Dell™ Technology Guide on your computer or at support.dell.com.
Back to Contents Page
Replacing the Optical Drive).
Replacing the Palm Rest).
Replacing the Display Assembly).
Replacing the Keyboard).
Replacing the Hinge Cover).
Fan).
Replacing a WLAN Card).
Replacing the Hard Drive).
Flashing the BIOS for more information).
Removing the System Board Assembly.