System > Trap Setting - D-Link 24-Port 10/100Mbps PoE Web Smart Switch with 4-Port 10/100/1000Base-T and 2-Port Combo SFP DES-1228P User Manual
24-port 10/100mbps poe web smart switch with 4-port 10/100/1000base-t and 2-port combo sfp
Hide thumbs
Also See for 24-Port 10/100Mbps PoE Web Smart Switch with 4-Port 10/100/1000Base-T and 2-Port Combo SFP DES-1228P:
- User manual (60 pages)
Table of Contents
Advertisement
Interval send IGMP v1 report packet by switch, it is for
SmartConsole Utility to discovery our switch when we in IGMP
protocol, zero means disable Group Interval, and 120~1225 means
send IGMP v1 report according the value which unit is seconds.
Figure 23 – System > System Setting
System > Trap Setting
By configuring the Trap Setting, it allows SmartConsole Utility to
monitor specified events on this Web-Smart Switch. By default, Trap
Setting is Disabled. When the Trap Setting is Enabled, enter the
Destination IP address of the managing PC that will receive trap
information.
3
5
3
5
Advertisement
Table of Contents
