Touch Pad Assembly; Figure 16. Touch Pad Removal - Dell Latitude LS Service Manual

22 Dell Latitude LS Portable Computers Service Manual
3. Reinstall the four black M2 x 4-mm screws that secure the top of the
palmrest assembly to the bottom-case assembly (see Figure 15).
4. Connect the touch pad flex cable to the ZIF connector on the system
board.
5. Connect the status lights flex cable to the ZIF connector on the system
board.
6. Turn the computer upside down.
7 . Reinstall the six M2.6 x 1.6-mm screws in the battery bay that secure
the bottom of the palmrest assembly to the bottom-case assembly
(see Figure 14).
8. Turn the computer right-side up.
9. Reinstall the keyboard assembly.
10. Reinstall the display assembly.
11. Reinstall the keyboard bezel.

Touch Pad Assembly

M2 x 3.5-mm screws (3)
touch pad holder
assembly
ZIF connector

Figure 16. Touch Pad Removal

1. Remove the keyboard bezel.
2. Remove the display assembly.
3. Remove the keyboard assembly.
4. Remove the palmrest assembly.
5. Remove the three M2 x 3.5-mm screws that secure the touch pad
assembly to the palmrest assembly (see Figure 16).
6. Slide the touch pad assembly out from under the two hold-down tabs.
7 . Remove the touch pad assembly from the palmrest assembly.
touch pad
flex cable