Display Assembly Latch; Figure 10. Display Assembly Latch Removal - Dell Latitude LS Service Manual

3. Separate the bezel from the display-assembly top cover.

Display Assembly Latch

Figure 10. Display Assembly Latch Removal

NOTICE: To avoid damaging the system board, you must remove the
main battery before you service the computer.
1. Remove the display assembly bezel.
2. Lift the display assembly latch of off the display-assembly top cover
3. Slide the latch spring off of the post on the display-assembly top cover
To replace the display-assembly latch, perform the following steps:
1. Carefully place the latch spring over the post on the display-assembly top
2. Holding the latch, stretch the spring slightly and set the display-assembly
3. Reinstall the bezel.
support.dell.com
The bezel is secured by slot openings that snap into the display-assembly
top cover. Carefully lift the inside edge of the bezel, working your way
around the inside perimeter, to unsnap and remove the bezel from the
display assembly.
latch spring
post
(see Figure 10).
(see Figure 10).
You may need to use a small flat-blade screwdriver to separate the latch
spring from the post.
cover.
You may need to use a small flat-blade screwdriver to place the spring over
the post. Hold the spring on the post with the screwdriver while
performing the next step.
latch in place in the display assembly top cover.
Dell Latitude LS Portable Computers Service Manual
display assembly latch
display assembly
top cover
13