34
Dell Inspiron 7500 — Removing and Replacing Parts
When replacing the palmrest assembly, orient the assembly in its original position on
the base assembly and press firmly near each tab until the palmrest assembly snaps
into place. Start at the front to align those tabs first. Make sure that all the tabs are
aligned.
Palmrest Assembly Component Removal
IR Board Removal
Figure 25. IR Board Components
IR cable
1
2
4-mm screws (2)
3
IR board
This procedure assumes that you have removed the palmrest assembly from the base
assembly. To remove the IR board (see Figure 24), perform the following steps:
1.
Remove the two 4-mm screws securing the IR board.
2.
Disconnect the IR cable from connector JP2 on the IR board.
3.
Remove the IR board.