Arming While Driving; Disarming; High Security Disarm - Avital 5103 Owner's Manual

➢ Arming while driving

Your security system can be armed while driving the vehicle.
Press on the transmitter for two seconds while the vehicle is running. The
siren will chirp once to indicate that the security system is armed, and then once
more to indicate that the ig ni tion is on. The system will not respond to any input
except the door triggers, and the starter kill relay (if installed) will not be acti-
vated. Once you have arrived at your des ti na tion, the system will disarm when
�������
the ignition is turned off. The siren will chirp twice and the LED will then stop
flashing. The system can also be disarmed at any time by pressing .

➢ Disarming

�������
To disarm the security system, press . You will hear two chirps, and the
parking lights will flash twice.
If the power locks are controlled by the system, the doors will also unlock. The
�������
siren chirping either four or five times when disarming indicates Tamper Alert,
which is described in the Diagnostics Section of this guide.

➢ High security disarm

This security system offers High Security Disarm. High Security Disarm is a fea-
ture that makes it possible to silence and reset the system while it is triggering,
without disarming the system. If the system is triggered and the siren has been
sounding for longer than six seconds, pressing on the remote transmitter will
stop the trigger and return the unit to the armed state. The system will not disarm,
but rather reset. This prevents you from disabling the system should you wish to
disarm it without visually checking the vehicle.
�������
Pressing after resetting the system will disarm the system; pressing this but-
ton during the first six seconds of the trig gered sequence will disarm the security
system immediately. The six second timer is provided for your con ve nience, in
case the system is accidentally triggered.
�������
reserved.
©2009 Directed Electronics. All rights
8