Setting The Treble Control; Turning Loudness On/Off - Alpine CDE-9845RB Owner's Manual

Setting the Treble Control

You can change the Treble Frequency emphasis to create your own
tonal preference.
1
CDE-9845RX:
Press CENTER f. to select the Treble Control
mode.
BASS → TREBLE → normal mode → BASS
CDE-9843RX/CDE-9841R:
Press MODE/LOUD to select the Treble Control
mode.
BASS → TREBLE → SUBW → BALANCE → FADER →
DEFEAT → VOLUME → BASS
2-1
Setting the treble Centre frequency:
Press g or f to select the desired treble
centre frequency.
7.5kHz ↔ 10.0kHz ↔ 12.5kHz ↔ 15.0kHz ↔ 7.5kHz
The displayed Treble frequency is emphasized.
2-2 *2
Setting the treble level:
Turn the Rotary encoder (CDE-9845RX) or press
4 4 4 4 4 and 3 3 3 3 3 (CDE-9843RX/CDE-9841R) to select the
desired treble level (-7~+7).
You can emphasize the treble frequency.
• If no operation is performed within 15 seconds, the treble control
setting will be turned off automatically.
• The treble level settings will be individually memorized for each
source (FM, MW (LW), CD, etc.) until the setting is changed. The
Treble frequency settings adjusted for one source are effective for
all other sources (FM, MW (LW), CD, etc.).
• This function is inoperable when DEFEAT is set to ON.
* 2 CDE-9845RX:
The adjustment can also be made by pressing the Rotary encoder
(MODE/LOUD). Refer to "Adjusting Bass/Treble/Balance
(Between Left and Right)/Fader (Between Front and Rear)/Defeat"
(page 14).

Turning Loudness On/Off

Loudness introduces a special low- and high-frequency emphasis at
low listening levels. This compensates for the ear's decreased
sensitivity to bass and treble sound.
Press and hold Rotary encoder (MODE/LOUD)
(CDE-9845RX) or MODE/LOUD (CDE-9843RX/CDE-
9841R) for at least 2 seconds to activate or deactivate
the loudness mode.
The display shows "LOUD ON" when the loudness mode is
activated.
15
-EN