Mitsubishi Electric UNISEN LT-40151 Owner's Manual page 80

80
Appendices
Appendix E: Troubleshooting, continued
General TV Operation
Symptom
1.
The TV remote control does not work.
2. When I try to use the remote control, the
POWER key blinks five times.
3.
TV does not respond to the remote control or
to control-panel buttons and TV will not power
on or off.
4. When a device is selected from the Activity
menu, the screen is blue or black (no signal
source).
5. You have forgotten your Lock menu pass code.
6. Rating restrictions are not working.
7. On-screen displays appear each time you
change a function.
8.
9. I have turned on CEC for my HDMI devices
but control is erratic and I wish to disable it.
Remarks
• Check that the batteries are fresh and installed correctly.
• Check that the control mode on the remote is set to TV.
• Be no more than 20 feet from the TV when using the remote control.
• Program the remote control to operate the TV or other device.
• Reset the remote control.
Replace the batteries.
• Unplug the AC power cord for 10 seconds.
• Press and hold the POWER button on the control panel to
perform system reset.
• Make sure the selected device is turned on.
• Begin play of the device.
See "Bypassing the Parental Lock", Appendix A.
Open the Lock > Parental Lock menu and:
• Verify that the ratings locks are active.
• Check the Lock Time/Unlock Time to check if rating restric-
tions are disabled.
• Rating restrictions apply only to content on the ANT input.
Normal TV operation.
• First turn off the TV's HDMI control for the specific device.
Open the Inputs > HDMI Control menu, select the device,
select Off.
• Disable CEC on the device itself. See the device's instruc-
tions.
• If the problem persists, do the following:
1. Disconnect the device from the TV.
2.
Open the Inputs > Name menu and select Delete for the
device.
3.
Reconnect the device to the TV and Auto Input Sensing
will recognize the device with CEC disabled.