Initial Netcommand Setup - Mitsubishi Electric UNISEN LT-40151 Owner's Manual

54
5. NetCommand IR Control

Initial NetCommand Setup

To perform this procedure, you need:
• The remote controls for both the TV and the
device you want to control.
• An IR emitter cable available from Mitsubishi
Note: To set up an A/V receiver, see "Setting Up A/V
Receiver Control," page 59.
1.
Connect and position the IR emitters for the
devices you wish to control. See "IR Emitter Place-
ment" on the previous page.
2.
Set the TV's remote control to TV mode and power
on the TV.
3.
Open the NetCommand
• If working from the
after the device is first detected, highlight
NetCommand and press ENTER to open the
Learn screen for the device.
• If performing NetCommand setup at any time
after the device has been recognized through
Auto Input Sensing:
a. Press ACTIVITY.
b. Highlight the desired input icon and press
ENTER to switch to that input.
c. Press MENU, highlight Inputs, and highlight
Learn to open the Inputs > Learn screen
for the device.
4.
The first function highlighted in the
is always Power On. Aim the TV's remote control
at the TV and press ENTER to begin learning for that
function.
5.
When the Power On text starts flashing, aim the
device's remote control at the TV and hold the POWER
key until a check mark appears next to Power On.
• If the text stops flashing before the check mark
appears, repeat the previous step.
• To remove the key from NetCommand control,
press the CANCEL key while the key name is
highlighted.
6.
Press the keys on the TV's remote control
to highlight other keys on the list. Repeat steps
4 and 5 for each additional function you wish to
control through NetCommand.
Note: Device keys in the far right column will be asso-
ciated with the remote control's MORE key when
"learned." See the table on page 56.
7.
If the device has a separate
on the TV's remote to highlight Power Off.
Repeat the earlier steps to "learn" the POWER OFF key.
If the device has no POWER OFF key, skip this step.
8.
Press BACK to finish NetCommand "learning" for the
current device.
Learn screen as follows:
New Device Found screen
Learn screen
POWER OFF key, press
.
From the New Device Found screen, highlight
NetCommand and press ENTER to open the Learn
screen.
Device-specific keys in the
rightmost column can be accessed
with the MORE key after "learning."
Adding or Removing Device Keys from
NetCommand Control
1.
Switch the TV to the device. Press
light the device's icon, and press ENTER.
2.
Open the Inputs menu and highlight the Learn icon.
3.
Learn screen displays:
When the
• To add keys:
under "Initial NetCommand Setup" on this
page.
To delete keys:
•
you wish to delete and press CANCEL on the
TV's remote control to clear the check mark.
Inputs > Learn screen
Key names marked with a
check have been "learned."
ACTIVITY, high-
Continue as described earlier
Highlight the name of the key