Operation - MULTIQUIP MAYCO LS600 Operation And Parts Manual

Radio Remote Control Programming
Before starting operation of the Radio Remote Control, go
to Screen 9 of the Digital Readout Screen:
RADIO ADDRESS
NO RADIO
PRESS RESET TO
LEARN A NEW ONE
1. Press the ON/OFF button on the radio (wireless) remote
control to turn on the power. Hold down the RESET switch.
The display will now show:
RADIO ADDRESS
NOW SCANNING
FOR NEW
TRANSMITTER
2. After 5 seconds, the display will show:
RADIO ADDRESS
COMMUNICATING
PRESS RESET TO
LEARN A NEW ONE
3. The remote control is now ready for use.
Cable Remote Control
Installation of the Cable Remote Control Assembly
Connect the cable to the front panel of the control box
(See Figure 38).
CABLE REMOTE CONTROL UNIT CABLE REMOTE CONTROL UNIT
PUMP REV
PUMP ON/OFF
Figure 38. Cable Remote Control
MAYCO LS600 PUMP — OPERATION AND PARTS MANUAL — REV. #4 (9/15/11) — PAGE 31
9
9
9
25 FT. CABLE 25 FT. CABLE
TO CONTROL BOX TO CONTROL BOX
CONNECTOR CONNECTOR
LS600 PUMP — OPERATION
Cable Remote Control Operation
Before using cable remote control, set the pumping volume
with the VOLUME switch on the control box then move the
Pumping Control Switch on the control box to the REMOTE
position.
The cable remote control (Figure 38) has the following
controls.
PUMP ON/OFF - Starts and stops the forward pumping.
PUMP REV - starts pumping in reverse direction.
WARNING - TRANSPORTING PUMP
It will be necessary at times to move your pump from
one job site location to another. Before moving the
pump, make sure to pump the remaining concrete out
of the hopper. Moving the pump with a full hopper of
concrete can cause severe damage or breakage of
the axle and axle springs, excess strain and pressure
on the hub and bearing assembly.
Leaking manifold seals or hose coupling
gaskets which leak water can cause sepa-
ration and subsequent jamming at that point.