Fujitsu M3099EH Operator's Manual page 82

Setting RS-232C transfer rate (M3099EX
When you set RS-232C transfer rate, you must set as follows:
1 In Screen 2, press
display RS-232C BAUD screen.
<Screen 24>
2 Press Mode 2 to display Screen 25.
(The default setting is 4800 bps.)
3 In Screen 25, press
you want to select blinks.
4 Press to display Screen 24.
Mode 2
The settings are stored in EEPROM.
5 When you close the setup mode, press
.
Stop
Setting SCSI-ID (M3099GX/GH)
When you set the picking start time, you must set as follows:
1 In Screen 2, press
display SCSI-ID SET screen.
<Screen 26 >
2 Press Mode 2 to display Screen 27.
(The default setting is "5".)
3 In Screen 27, press
SCSI-ID. Each time
SCSI-ID changed from 0 to 7.
4 Press Mode 2 to display Screen 26.
The settings are stored in EEPROM.
5 When you close the setup mode, press
.
Stop
12 times to
Mode 1
until the rate
Mode 1
12 times to
Mode 1
to change
Mode 1
is pressed,
Mode 1
/ EH)
<Screen 24>
< < S E T U P
R S 2 3
<Screen 25>
< < S E T U P
9 6 0 0 : 4 8
(Blinking)
<Screen 26>
< < S E T U P
S C S
<Screen 27>
S C S
>
>
M O D E
2 C B A U D
>
>
M O D E
0 0 : 2 4 0 0
: 1 2 0 0
> >
M O D E
I - I D S E T
I - I D S E T
5
7-11