Fujitsu M3099EH Operator's Manual page 57

CAUTION
Do not feed an important original document to prevent damage to it in rare
case.
When scanning a translucent document, set the density to light mode.
To prevent roller smudging, avoid scanning a document filled out in pencil. Clean the roller as often as
possible when scanning many document. Once every 1000 sheets is recommended.
The chemical composition of some carbonless papers may react with the roller rubber and damage the
rubber. Check the carbonless papers before use.
The carbonless papers may be used if:
• Paper weight is 52 g/m
• Hopper load is 500 sheets or fewer.
NOTE
• If carbonless papers are used, clean the roller twice as often as usual.
• Paper should be straightened to fit the condition below.
• Some papers might have a curl on the stack when you use curled paper having some fold wrinkle.
2
(13.9 lb) or more.
More than
30 mm
Less than
3 mm
Top of the paper
More than
30 mm
Less than
5 mm
Feed direction
Read surface
Feed direction
Read surface
4-3