Fujitsu M3099EH Operator's Manual page 26

<IPC-2 pre-set mode>
S c a n n
The abrasion counter is displayed when
Ready screen.
The abrasion counter displays the accumulative number of read
document.
This counter can be reset to zero by following the procedure shown
in Chapter 7 (page 7-7).
The reading counter or abrasion counter disappears when:
• The next start commnad is issued.
• The valid switches are pressed.
• The error is cleared.
S c a n n
When IPC-2 pre-set mode is set, an asterisk (
The method of IPC-2 pre-set mode is shown in setup mode.
e r R e a d X
X X
Abrasion
counter
is pressed in the
Stop
e r R e a d y
) is displayed.
X X X
1-13