Fujitsu M3099EH Operator's Manual page 69

How to reset the print head life counter
You must reset the print head life counter when you replace the print head.
13 In Screen 1, press
display INK RESET screen. <Screen 12>
14 Press Mode 2 to display Screen 13. If you
want to reset the counter, press
And you can see Screen 14 for 3 seconds.
If you do not want it, press
Screen 12.
Go to 7 to close the job.
How to test the printing using the operator panel
You can check the print result as follows:
15 Turn the endorser on by following the
procedure of "page 6-2, How to set the
endorser ON (or OFF)".
16 Turn the power of the scanner on while
pressing Mode 2 . The LCD displays MAIN-
TENANCE MODE initial screen.
<Screen 15>
17 Press Mode 2 once, then press
Place a document on the stacker, then
press .
Start
NOTE
• The scanner prints 5-digit numbers counting in increment of one from the
initial number.
• Before pressing
on (See Chapter 3).
Mode 1 11 times to
Mode 2 .
to go
Mode 1
Mode 1 once.
you can set the document size, resolution and so
Start
<Screen 12>
< < S E T U P
I N K
<Screen 13>
I N K
N o - M o d e 1
<Screen 14>
R E S E T
F i n i s h
<Screen 15>
< < C E
T E S T x x
>
>
M O D E
R E S E T
R E S E T
- M o d e 2
Y e
s
! !
> >
M O D E
: S T A R T
6-5