B Preparation
Connecting the Projector
Notes
• Make sure all the equipment is powered off when connecting the projector.
• Use the proper cables for each connection.
• Insert the cable plugs firmly; Loose connections may reduce performance of picture signals or
cause a malfunction. When pulling out a cable, be sure to grip it by the plug, not the cable itself.
• For more information, refer also to the instruction manuals of the equipment you are connecting.
• Use a no-resistance audio cable.
Connecting a Computer
Connection with a computer is explained for each input signal.
INPUT A
For connecting a computer with an RGB output connector.
Computer
Note
It is recommended that you set the resolution of your computer to 1024 × 768 pixels (VPL-DX146/
DX126) or 1280 × 800 pixels (VPL-DW126) for the external monitor.
INPUT B
For connecting a computer with an HDMI output connector.
Computer
Notes
• Use HDMI-compatible equipment which has the HDMI Logo.
• Use a high speed HDMI cable(s) on which the cable type logo is specified. (Sony products are
recommended.)
• The HDMI connector of this projector is not compatible with DSD (Direct Stream Digital) Signal
or CEC (Consumer Electronics Control) Signal.
• It is recommended that you set the resolution of your computer to 1024 × 768 pixels (VPL-DX146/
DX126) or 1280 × 800 pixels (VPL-DW126) for the external monitor.
8
Connecting the Projector
Mini D-sub 15-pin cable (supplied)
RGB output
connector
Audio output
connector
Audio cable (Stereo mini plug)
(not supplied)
HDMI cable
HDMI output
(not supplied)
connector