Regulatory Information - Oki MB760 Material Safety Data Sheet

Regulatory Information

ENERGY STAR
As an ENERGY STAR Partner, Oki Data has
determined that this product meets the
ENERGY STAR guidelines for energy
efficiency.
Federal Communications Commission
(FCC)
Declaration of Conformity
Product Name
MB760, 120V
MB770, 120V
MPS5502mb, 120V
MB770f, 120V
MB770fx, 120V
MPS5502mbf, 120V
MPS5502mbfx, 120V
MB760, 230V
MB770, 230V
MPS5502mb, 230V
MB770f, 230V
MB770fx, 230V
MPS5502mbf, 230V
MPS5502mbfx, 230V
1. Statement
This device complies with Part 15 of the FCC Rules.
Operation is subject to the following two conditions: (1)
This device may not cause harmful interference, and (2)
this device must accept any interference received,
including interference that may cause undesired
operation.
2. Responsible Party
Oki Data Americas, Inc.
2000 Bishops Gate Boulevard
Mt. Laurel, NJ 08054-4620
1-800-654-3282 (1-800-OKI-DATA)
FCC Radio Frequency Interference Statement
WARNING: This equipment has been tested and found to
comply with the limits for a Class A digital device, pursuant
to Part 15 of the FCC rules. These limits are designed to
provide reasonable protection against harmful interference
in a commercial environment. This equipment generates,
uses and can radiate radio frequency energy and, if not
installed and used in accordance with the instructions, may
cause harmful interference to radio communications.
Operation of this equipment in a residential area is likely to
cause harmful interference in which case the user will be
required to correct the interference at their own expense.
®
Model Name
N22400A
N22400A
N22400A
N22401A
N22401A
N22401A
N22401A
N22400B
N22400B
N22400B
N22401B
N22401B
N22401B
N22401B
7 - English
Note: It is the responsibility of the user to obtain the
required shielded cable in order to ensure
compliance of this equipment with FCC regulations.
Changes or modifications not expressly approved by Oki
Data may void your authority to operate this device.
FCC Administrative Council for Terminal
Attachment Requirements for End Users
This device has been granted a registration number by the
Administrative Council for Terminal Attachment (ACTA),
under Part 68 and ACTA rules and regulations for direct
connection to the telephone lines. In order to comply with
these FCC rules, the following instructions must be
carefully read and applicable portions followed completely.
1. This equipment complies with Part 68 of FCC rules and
the requirements adopted by the ACTA. On the back of
the equipment is a label that contains, among other
information, a product identifier in the format
US:AAAEQ##TXXXX. If requested, this inf
2. The following USOC jacks may be used with this
equipment: RJ11C.
3. A plug and jack used to connect this equipment to the
premises wiring and telephone network must comply
with the applicable FCC Part 68 rules and requirements
adopted by the ACTA. A compliant telephone cord and
modular plug is provided with this product. It is
designed to be connected to a compatible modular jack
that is also compliant. See installation instructions for
details.
4. The REN is used to determine the quantity of devices
which may be connected to the telephone line.
Excessive RENs on the telephone line may result in the
devices not ringing in response to an incoming call. In
most, but not all areas, the sum of the RENs should not
exceed five (5.0). To be certain of the number of
devices that may be connected to the line, as
determined by the total RENs, contact the local
telephone company. For products approved after July
23, 2001, the REN for this product is part of the product
identifier that has the format US:AAAEQ##TXXXX. The
digits represented by ## are the REN without a decimal
point (e.g., 03 is a REN of 0.3). For earlier products, the
REN is separately shown on the label.
5. If the equipment, MB760/MB770/MB770f/MB770fx/
MPS5502mb/MPS5502mbf/MPS5502mbfx, causes harm
to the telephone network, the telephone company will
notify you in advance that temporary discontinuance of
service may be required. But if advance notice isn't
practical, the telephone company will notify the
customer as soon as possible. Also, you will be advised
of your right to file a complaint with the FCC if you
believe it is necessary.
6. The telephone company may make changes in its
facilities, equipment, operations, or procedures that
could affect the operation of the equipment. If this
happens, the telephone company will provide advance
notice in order for you to make the necessary
modifications to maintain uninterrupted service.
7. If trouble is experienced with this equipment (MB760/
MB770/MB770f/MB770fx/MPS5502mb/MPS5502mbf/
MPS5502mbfx), please contact the following for repair
and/or warranty information:
Oki Data Americas, Inc.
2000 Bishops Gate Blvd.
Mount Laurel, N.J. 08054-4620
Telephone:(856) 235-2600 or
(800)-OKIDATA (800-654-3282)