HP 240 Maintenance And Service Manual page 58

To remove the WLAN module:
1. Loosen the memory module/wireless module compartment cover screw (1), and then lift up on
the tab (2) and remove the cover (3). The memory module/wireless module compartment cover
is available in the Plastics Kit. For more information about the Plastics Kit, see
on page
2. Disconnect the WLAN antenna cables (1) from the terminals on the WLAN module.
NOTE:
WLAN antenna cable is connected to the WLAN module Aux terminal.
3. Remove the Phillips PM2.0×3.0 screw (2) that secures the WLAN module to the system board.
(The WLAN module tilts up.)
4. Remove the WLAN module by pulling the module away from the slot at an angle (3).
50 Chapter 4 Removal and replacement procedures
26.
The #1 WLAN antenna cable is connected to the WLAN module Main terminal. The #2
Plastics Kit