Table of Contents
Advertisement
4.
Tighten the captive screws to secure the stand to the chassis.
Figure 2-17
5.
Align the top of the back of the stand with the stand, and press it into place, working along the
sides until it is in place.
Figure 2-18
Removing a tilt/swivel stand
To remove the stand:
1.
Remove all removable media, such as compact discs or USB flash drives, from the computer.
2.
Turn off the computer properly through the operating system, then turn off any external devices.
3.
Disconnect the power cord from the power outlet and disconnect any external devices.
CAUTION:
power to drain before adding or removing memory modules. Regardless of the power-on state,
voltage is always supplied to the memory modules as long as the computer is plugged into an
active AC outlet. Adding or removing memory modules while voltage is present may cause
irreparable damage to the memory modules or system board.
4.
Remove/disengage any security devices that prohibit opening the computer.
Securing the stand
Installing the back of the stand
You must disconnect the power cord and wait approximately 30 seconds for the
Installing and removing a stand
23
Hide quick links:
Advertisement
Table of Contents
