Installing The New Optical Drive - HP EliteDesk 800 Hardware Reference Manual

Installing the new optical drive

NOTE: If you are installing an optical drive in a bay that did not previously have a drive in it, you
must remove the access panel, the front bezel, and the bezel blank covering the opening of the bay
before proceeding. Follow the procedures in
Removing a bezel blank on page
1. Follow the instructions for removing the optical drive if one was installed. Refer to
optical drive on page
2. Attach the release latch to the new optical drive. Refer to
on page
3. Slide the optical drive through the front bezel all the way into the bay so that it locks in place (1),
then connect the cable to the rear of the drive (2).
4. Replace the computer access panel.
5. If the computer was on a stand, replace the stand.
6. Reconnect the power cord and turn on the computer.
7. Lock any security devices that were disengaged when the computer cover or access panel was
removed.
ENWW
103.
111.
112.
Removing the computer access panel on page 100
Preparing the new optical drive
Removing the
Replacing the optical drive 113
and