Installing The New Optical Drive - HP SignagePlayer mp8200 Hardware Reference Manual

Installing the New Optical Drive

NOTE:
If you are installing an optical drive in a bay that did not previously have a drive in it, you
must remove the access panel and the bezel blank covering the opening of the bay before proceeding.
Follow the procedures in
Blank on page
1. Follow the instructions for removing the optical drive. Refer to
on page
2. Attach the release latch to the new optical drive. Refer to
on page
3. With the back of the optical drive facing the computer and the release latch on the inner side of
the drive, align the drive with the opening in the front bezel.
4.
Slide the optical drive through the front bezel all the way into the bay so that it locks in place (1),
then connect the cable to the rear of the drive (2).
Figure 2-14
5. Replace the front bezel and access panel.
6.
If the computer was on a stand, replace the stand.
7.
Reconnect the power cord and turn on the computer.
8.
Lock any security devices that were disengaged when the computer cover or access panel was
removed.
24 Chapter 2 Hardware Upgrades
Removing the Computer Access Panel on page 10
13.
21.
23.
Installing the Optical Drive
and Removing a Bezel
Removing the Optical Drive
Preparing the New Optical Drive