HP EliteDesk 800 Hardware Reference Manual page 118

8. To remove a SODIMM, press outward on the two latches on each side of the SODIMM (1) then
pull the SODIMM out of the socket (2).
NOTE:
lock before removing or installing a SODIMM.
9. Slide the new SODIMM into the socket at approximately a 30° angle (1) then press the SODIMM
down (2) so that the latches lock it in place.
NOTE:
with the tab on the memory socket.
10. Replace the access panel.
11. If the computer was on a stand, replace the stand.
110 Chapter 4 Ultra-slim Desktop (USDT) hardware upgrades
If a solenoid hood lock is installed in the computer, it may be necessary to remove the
A memory module can be installed in only one way. Match the notch on the module
ENWW