Card Stock - Dell 1815dn Multifunction Mono Laser Printer User Manual

- Contain windows, holes, perforations, cutouts or embossing
- Use metal clasps, string ties, or metal folding bars
- Have an interlocking design
- Have postage stamps attached
- Have any exposed adhesive when the flap is in the sealed or closed position
- Have nicked edges or bent corners
- Have rough, cockle, or laid finishes
Use envelopes that can withstand temperatures of 180° C (356° F) without sealing, excessive curling, wrinkling, or releasing hazardous emissions. If
l
you have any doubts about the envelopes you are considering using, check with the envelope supplier.
Adjust the width guide to fit the width of the envelopes.
l
Load an envelope with the flap side down and with the stamp area on the top left side. The end of the envelope with the stamp area enters the bypass
l
tray first.
See "Using the Bypass Tray"
A combination of high humidity (over 60%) and the high printing temperatures may seal the envelopes.
l
Labels
Your printer can print on many labels designed for use with laser printers. These labels are supplied in letter size, A4 size, and legal size sheets. Label
adhesives, face sheet (printable stock), and topcoats must be able to withstand temperatures of 180° C (356° F) and pressure of 25 pounds per square inch
(psi). You can load one label sheet at a time in the bypass tray.
Try a sample of any label you are considering using with the printer before purchasing a large quantity:
Use full label sheets. Partial sheets may cause labels to peel off during printing, resulting in a jam. Partial sheets also contaminate your printer and your
l
cartridge with adhesive, and could void your printer and cartridge warranties.
Use labels that can withstand temperatures of 180° C (356° F) without sealing, excessive curling, wrinkling, or releasing hazardous emissions.
l
Do not print within 0.04 in. (1 mm) of the edge of the label, of the perforations, or between die-cuts of the label.
l
Do not use label sheets that have adhesive to the edge of the sheet. We recommend zone coating of the adhesive at least 0.04 in. (1 mm) away from
l
edges. Adhesive material contaminates your printer and could void your warranty.
If zone coating of the adhesive is not possible, a 0.125 in. (3 mm) strip be removed on the leading and driver edge, and a non-oozing adhesive should be
l
used.
Remove a 0.125 in. (3 mm) strip from the leading edge to prevent labels from peeling inside the printer.
l
Portrait orientation is preferred, especially when printing bar codes.
l
Do not use labels that have exposed adhesive.
l

Card Stock

for instructions on loading an envelope.