Dell PowerConnect B-RX Configuration Manual page 309

•
Figure 13
configuration does not aggregate ports but uses the LACP PDUs to maintain the connection status
between the two ports.
FIGURE 13
Figure 14
end are on the same interface module. Ports in a valid 2-port LAG on one device are connected to
two ports in a valid 2-port LAG on another device.
FIGURE 14
G
Figure 15
end of the LAG are on different interface modules.
BigIron RX Series Configuration Guide
53-1001986-01
To change port parameters, you must change them on the primary port. The software
automatically applies the changes to the other ports in the LAG.
Make sure the device on the other end of the trunk link can support the same number of ports
in the link.
displays and example of a valid, Keep ALIVE LAG link between two devices. This
Example of a 1-port keep alive LAG
Port1/1
Port1/2
Port1/3
Port1/4
Port1/5
Port1/6
Port1/7
Port1/8
shows an example of a valid 2-port LAG link between devices where the ports on each
Example of 2-port LA
Port1/1
Port1/2
Port1/3
Port1/4
Port1/5
Port1/6
Port1/7
Port1/8
shows and example of two devices connected over a 4 port LAG where the ports on each
LAG formation rules
Port1/1
Port1/2
Port1/3
Port1/4
Port1/5
Port1/6
Port1/7
Port1/8
Port1/1
Port1/2
Port1/3
Port1/4
Port1/5
Port1/6
Port1/7
Port1/8
8
237