Dell PowerConnect B-RX Configuration Manual page 107

To view the redundancy parameter settings and statistics, enter the following command at any level
of the CLI.
BigIron RX# show redundancy
=== MP Redundancy Settings ===
Default Active Slot = 17
Running-Config Sync Period = 7 seconds
=== MP Redundancy Statistics ===
Current Active Session:
Active Slot = 9,Standby Slot = 10 (Ready State),Switchover Cause = No Switchover
Start Time = 0-0-17
Previous Active Session #1:
Active Slot = 10, Standby Slot = 9, Switchover Cause = Active Rebooted
Start Time = 0-0-17
Previous Active Session #2:
Active Slot = 9, Standby Slot = 10, Switchover Cause = Active Rebooted
Start Time = 0-0-17
...
This output displays that the default active chassis slot is configured as slot 9 (M1) and the
automatic synchronization interval is configured for 7 seconds. It also displays that in the current
active session, the module installed in slot 9 (M1) is the active module, the module installed in slot
10 (M2) is the standby module, which is in Ready state, and no switchovers have occurred.
However, in two previous sessions, switchovers occurred because the active module was rebooted.
In session #2, the module installed in slot 9 (M1) was the active module, while the module
installed in slot 10 (M2) was the standby module. In session #1, the module installed in slot 10
(M2) was the active module, while the module installed in slot 9 (M1) was the standby module.
To view the system log or the traps logged on an SNMP trap receiver, enter the following command
at any level of CLI.
BigIron RX Series Configuration Guide
53-1001986-01
Monitoring management module redundancy
19:47:39 (Wednesday)
19:46:9 (Wednesday), End Time = 0-0-17
19:44:14 (Wednesday), End Time = 0-0-17
3
19:47:39 (Wednesday)
19:46:9 (Wednesday)
35