Brocade Communications Systems PowerConnect B-FCXs Release Note page 48

Defect ID: DEFECT000318038
Summary: The switch may reload if you issue "no owner prio <pri>" command before you configure
"owner".
Feature: SX Layer3 Control Protocols
Reported In Release: FI 07.1.00
Defect ID: DEFECT000278649
Summary: The command 'gig-default auto-gig' does not appear in the running configuration.
Symptom: The command 'gig-default auto-gig' does not appear in the running configuration.
Workaround: No. If the connected end with all ports are same Gigabit configuration, gig-default
config in global level would be workaround.
Probability: Medium
Feature: SX Layer1 features
Reported In Release: FI 05.1.00
Defect ID: DEFECT000301157
Summary: sFlow is not sampling the traffic on the standby and member units on a FGS/FLS stack.
Feature: FCX Network Management
Reported In Release: FI 07.2.00
Defect ID: DEFECT000304374
Summary: snAgGblDynMemUtil MIB object does not return the correct value.
Feature: SX Network Management
Reported In Release: FI 07.2.00
Defect ID: DEFECT000309430
Summary: The switch may run out of available memory when there is continual SNMP polling to the
device.
Symptom: Router reloaded.
Probability: Medium
Feature: SX Network Management
Reported In Release: FI 07.0.01
Defect ID: DEFECT000310242
Summary: DHCPS: Released IP addresses are withheld from distribution if an ARP entry exists for that
IP Address.
Feature: FCX DHCP
Reported In Release: FI 07.2.00
IronWare Software Release 07.2.00a for Brocade FastIron switches
Release Notes v 1.0
Technical Severity: Medium
Function: VRRP/VRRP-E and slow-start timer-
VRRP-E timer scale
Technical Severity: Medium
Function: link status - speed and duplex status
Service Request ID: 239173
Technical Severity: High
Function: sFlow
Technical Severity: Medium
Function: SNMP V4/V6
Technical Severity: High
Function: SNMP V4/V6
Service Request ID: 259419
Technical Severity: High
Function: Server
Page 48 of 55