TRENDnet TEW-751DR User Manual page 37

TRENDnet User's Guide
3. Review the virtual server settings. Click Save Settings to save settings.
Check the option to the left most of the entry to enable and uncheck to disable.
• Name – Enter a name for the virtual server.
Note: You can also click the Application Name drop-down list to select from a
predefined list of applications and click << to copy the information into the fields.
• IP Address: Enter the IP address of the device to forward the port (e.g.
192.168.10.101).
Note: You can also click the Computer Name drop-down list to select a computer
from the DHCP client list and click << to copy the information into the field.
• Public Port – Enter the port number used to access the device from the Internet.
• Private Port – Enter the port number required by your device. Refer to the
connecting device's documentation for reference to the network port(s) required.
• Protocol: Select the protocol required for your device. TCP, UDP, Both (TCP and
UDP), or Other to define a non-listed protocol.
Note: The Public Port can be assigned a different port number than the Private
Port (also known as port redirection), however it is recommended to use the same
port number for both settings. Please refer to the device documentation to
determine which ports and protocols are required.It is recommended to assign a
static IP address to the device or use DHCP reservation to ensure the IP address of
the device does not change.
• Schedule: Select the defined schedule you would like to have the rule to be
applied (see "Create Schedule" section on page 35).
• Inbound Filter: Select the defined IP address range to allow access. (see
Filter" section on page 40).
© Copyright 2013 TRENDnet. All Rights Reserved.
Example: To forward TCP port 80 to your IP camera
1. Setup DynDNS service (see
2. Access TRENDnet IP Camera management page and forward Port 80 (see product
documentation)
3. Make sure to configure your network/IP camera to use a static IP address.
Note: You may need to reference your camera documentation on configuring a static IP
address.
4. Log into your router management page (see
on page 25).
5. Click on Access, and click on Virtual Server.
6. Check the option next to the virtual server entry to enable.
7. Under Name, click the Application Name drop-down list and select the predefined
HTTP entry, then click << to copy the application information to the fields.
8. Next to IP Address, enter the IP address assigned to the camera. (e.g. 192.168.10.101)
9. Next to Protocol, make sure TCP is selected in the drop-down list.
10. The Private Port and Public Port, make sure port number 80 is configured for both
"Inbound
settings.
11. To save the changes, click Save Settings.
Identify Your Network section page 33).
"Access your router management
TEW-751DR
page"
37