B.1 Setting Terminals (Mp Model); Table B.1 Setting Terminal: Cn2 (Mp Model) - Fujitsu MAM3184MC/MP Product/Maintenance Manual

B.1 Setting Terminals (MP model)
Setting item Pins
9 - 10 7 - 8
SCSI ID (Open) Open
(Open) Open
(Open) Open
(Open) Open
(Open) Short
(Open) Short
(Open) Short
(Open) Short
Short
Short
Short
Short
Short
Short
Short
Short
Write protect Open
Short
Setting item
11 - 12
Motor start mode Open
Short
Force Narrow
Force Single Ended
Terminating power supply
* Default
Note:
See the description of Section 5.3 for details of the setting requirements and notes.
B - 2
Table B.1 Setting terminal: CN2 (MP model)
5 - 6 3 - 4 1 - 2
Open Open
Open Short
Short Open
Short Short
Open Open
Open Short
Short Open
Short Short
Open Open Open
Open Open Short
Open Short Open
Open Short Short
Short Open Open
Short Open Short
Short Short Open
Short Short Short
Pins
13 - 14 15 - 16 23 - 24
Open
Short
Open
Short
Open
Short
C141-E134-01EN
Setting contents
SCSI ID #0 (Common to 8-bit and 16-bit SCSI)
SCSI ID #1 (Common to 8-bit and 16-bit SCSI)
SCSI ID #2 (Common to 8-bit and 16-bit SCSI)
SCSI ID #3 (Common to 8-bit and 16-bit SCSI)
SCSI ID #4 (Common to 8-bit and 16-bit SCSI)
SCSI ID #5 (Common to 8-bit and 16-bit SCSI)
SCSI ID #6 (Common to 8-bit and 16-bit SCSI)
SCSI ID #7 (Common to 8-bit and 16-bit SCSI)
SCSI ID #8 (16-bit SCSI only)
SCSI ID #9 (16-bit SCSI only)
SCSI ID #10 (16-bit SCSI only)
SCSI ID #11 (16-bit SCSI only)
SCSI ID #12 (16-bit SCSI only)
SCSI ID #13 (16-bit SCSI only)
SCSI ID #14 (16-bit SCSI only)
SCSI ID #15 (16-bit SCSI only) (*)
Write operation is enabled. (*)
Write operation is disabled.
Setting contents
Started by the START/STOP command
Started by turning the power supply on (*)
Width of 16 bit bus (*)
Width of 8 bit bus
Follows DIFFSNS signal level on SCSI bus (*)
Single-Ended mode
Does not supply terminating resistor power to SCSI BUS
Supply terminating resistor power to SCSI BUS (*)