Setting Terminals (On Np Model Only); Table A.1 Cn2 Setting Terminal (On Np Model Drives Only) - Fujitsu MBA3073NC Product Manual

A.1

Setting Terminals (on NP model only)

Table A.1
Setting item
1 - 2 3 - 4
SCSI ID Open Open
Short Open
Open Short
Short Short
Open Open
Short Open
Open Short
Short Short
Open Open
Short Open
Open Short
Short Short
Open Open
Short Open
Open Short
Short Short
Write protect
Setting item
11 - 12
Motor start mode Open
Short
Force Narrow
Force Single Ended
Terminating power supply
* Setting at factory shipment
Note:
See the description of Section 5.3 for details of the setting requirements and notes.
118
CN2 setting terminal (on NP model drives only)
Pin pair
5 - 6 7 - 8 9 - 10
Open (Open) SCSI ID #0
Open (Open) SCSI ID #1
Open (Open) SCSI ID #2
Open (Open) SCSI ID #3
Short (Open) SCSI ID #4
Short (Open) SCSI ID #5
Short (Open) SCSI ID #6
Short (Open) SCSI ID #7
Open Short SCSI ID #8
Open Short SCSI ID #9
Open Short SCSI ID #10 (16-bit SCSI only)
Open Short SCSI ID #11 (16-bit SCSI only)
Short Short SCSI ID #12 (16-bit SCSI only)
Short Short SCSI ID #13 (16-bit SCSI only)
Short Short SCSI ID #14 (16-bit SCSI only)
Short Short SCSI ID #15 (16-bit SCSI only) (*)
Open Write operation is enabled. (*)
Short Write operation is disabled.
Pin pair
13 - 14 15 - 16 23 - 24
Open
Short
Open
Short
Open
Short
Setting contents
(Common to 8-bit and 16-bit SCSI)
(Common to 8-bit and 16-bit SCSI)
(Common to 8-bit and 16-bit SCSI)
(Common to 8-bit and 16-bit SCSI)
(Common to 8-bit and 16-bit SCSI)
(Common to 8-bit and 16-bit SCSI)
(Common to 8-bit and 16-bit SCSI)
(Common to 8-bit and 16-bit SCSI)
(16-bit SCSI only)
(16-bit SCSI only)
Setting contents
Started by the START/STOP command
Started by turning the power supply on (*)
Width of 16-bit bus (*)
Width of 8-bit bus
Follows DIFFSNS signal level on SCSI bus (*)
Single-Ended mode
Does not supply terminating resistor power to SCSI BUS
Supply terminating resistor power to SCSI BUS (*)
C141-E270