Table of Contents
Advertisement
When the revision number is changed after the drive is shipped from
the factory, Fujitsu issues "Engineering Change Request/Notice" in
which the new revision number is indicated. When the user changes
the revision number, the user should update the revision label as
described in item (2) after applying the modification.
At shipment
Revising at field
2.1.5
Tools and test equipment
Disk drive troubleshooting and repair in the field require only standard hand tools. No special
tools or test equipment are required.
This manual does not describe the factory-level tools and test equipment.
2.1.6
Self-diagnostic functions
IDD has the following self-diagnostic functions for checking basic operation of a single IDD:
Initial self-diagnosis
Offline self-diagnosis (using Send Diagnostic command)
For details of these self-diagnostic functions, refer to the Product Manual.
2.1.7
Tests
This disk drive can be tested in the following ways:
2 - 6
IMPORTANT
Figure 2.2
Indicating revision numbers
C141-F037-02EN
Rev. A2
Rev. A3
Advertisement
Table of Contents
Troubleshooting
