Step Three: Clean The Tank; Step Four: Replace The Water Level Sensor - Honeywell HCM-631N - Quietcare 3 Gallon Owner's Manual

STEP THREE: Clean the Tank
1
STEP FOUR: Replace the Water Level Sensor (if necessary)
WARNING: Electrocution Hazard.
TrueSTEAM must be unplugged before removing the cover. Hazardous voltage could cause
death or serious injury.
2
5
M29632
TrueSTEAM Humidification System 69-2285—01
Use tap water to flush loose minerals from the tank:
• Sediment screen at tank's bottom is removable.
• For a more thorough cleaning, soak tank in water
with CLR
rinse clean.
• Tank is dishwasher safe.
• Do not use hydrocarbon-based cleaners.
Unplug the power cord and carefully rub minerals off of
the heating element and tank walls. Clear the sensor
compartment holes of debris, if present.
2
M29631
Remove TrueSTEAM cover and inspect water
level sensor. If debris buildup is present, clean with
recommended cleaning agent. If cracks or visible
1
discoloration is noticed, replace sensor (see below).
Remove T-30 Torx screw and lift clamp.
Remove the sensor.
3
Ensure sensor gaskets are seated properly and are
4
in good condition (no cracks). If cracks are noticed,
replace water sensor assembly (including gaskets).
Install a new sensor if excessive mineral deposits are
present, or if gaskets are in poor condition. See "Parts
List" on page 59.
, LimeAway or white vinegar. Then
® ®
49