Water Supply And Drain Connections; Step One: Connect The Cold Water Supply; Step Two: Tap Into A Water Line - Honeywell HCM-631N - Quietcare 3 Gallon Owner's Manual

BEST
PRACTICE

Water Supply and Drain Connections

STEP ONE: Connect the Cold Water Supply
5
STEP TWO: Tap into a Water Line
Water Supply
Line
Manual Shutoff
Valve
T-fitting
TrueSTEAM Humidification System 69-2285—01
Use a manual shutoff valve when tapping into a water line.
2
1
4 3
MCR32911
Saddle Valve
M29605
Do not use hot water supply. Cold water is required to
cool boiling water to safe draining temperatures.
Insert one end of the water line into the water filter
or reverse osmosis kit. Use the 1/4-inch plastic water
line provided or a 1/4-inch copper water line. Apply a
modest pull to ensure a tight fit.
Use clamps or ties to secure the water filter in a
location that allows for removing and replacing it in the
future. Honeywell recommends changing the water
filter or RO canisters 1 & 2 annually, or as needed
based on water conditions.
Install the provided backflow preventer, as required
by code. See "Appendix F: Reverse Osmosis Filter" if
using the Reverse Osmosis Filter.
Cut the water line so it is long enough to reach from
the water filter to the supply fitting on the bottom
of the TrueSTEAM.
Insert the water line into the TrueSTEAM
supply fitting.
Note: Failure to check for a tight fit with plastic water line
could result in the line coming loose in the future. Apply
modest pull to ensure water line is properly seated and
secure.
• Consult local codes for proper plumbing.
• Use the saddle valve provided or a T-fitting and
manual shutoff valve to tap into a cold water line.
• Refer to the literature included with the valve you
chose and the local plumbing codes. Use proper
technique for the valve.
13