Pioneer AVX-7000 Manual

7 inch wide av system display
Hide thumbs Also See for AVX-7000:

Advertisement

7 INCH WIDE AV SYSTEM DISPLAY
Manual
AVX-7000

Advertisement

Table of Contents
loading

Summary of Contents for Pioneer AVX-7000

  • Page 1 7 INCH WIDE AV SYSTEM DISPLAY Manual AVX-7000...
  • Page 2: Table Of Contents

    &RQWHQWV Installation ..........3 Operation of the Display ..... 13 DIN Front/Rear-mount ........3 Deploying the Display........13 DIN Front-mount ..........3 Screen Angle Adjustment ......... 14 DIN Rear-mount ..........4 Closing the Display ........... 15 Brightness Adjustment ........16 Switching the Auto-Dimmer Mode....
  • Page 3: Installation

    ,QVWDOODWLRQ • Before finally installing this product, connect the wiring temporarily, making sure it is all connected up properly, and this product and the system work properly. • Use only the parts included with this product to ensure proper installation. The use of unauthorized parts can cause malfunctions.
  • Page 4: Din Rear-Mount

    ,QVWDOODWLRQ Removing this product. 5. Frame Pull out to remove the frame. (When reattaching the frame, point the side with a groove downwards and attach it.) 6. Insert the supplied extraction keys into the unit, as shown in the figure, until they click into place. Keeping the keys pressed against the sides of the unit, pull the unit out.
  • Page 5: Connecting The Units

    &RQQHFWLQJ WKH 8QLWV • This unit is for vehicles with a 12-volt battery and negative grounding. Before installing it in a recreational vehicle, truck, or bus, check the battery voltage. • To avoid shorts in the electrical system, be sure to disconnect the battery cable before beginning installation.
  • Page 6: Connection Diagram

    &RQQHFWLRQ 'LDJUDP Connecting the Power Cord • This product conforms to new cord colors. This Product Yellow Fuse holder To terminal always supplied with power regardless of ignition switch position. Fuse resistor To electric terminal controlled by ignition switch (12 V DC) ON/OFF. Orange Fuse resistor To lighting switch terminal.
  • Page 7: Connecting The System (A)

    Connecting the System (A) Speaker Unit (supplied) Not Used. Navigation System (sold separately) This Product 15 cm Gray 50 cm Green Gray RGB cable (supplied)
  • Page 8: Connecting The System (B)

    &RQQHFWLRQ 'LDJUDP Connecting the System (B) Gray Green Navigation System (sold separately) Audio Visual Master Unit (sold separately) Green Blue RGB cable (supplied V.SEL cable with the Audio Visual (supplied) Master Unit) Multi-CD player (sold separately) Gray Speaker Unit (supplied) This Product 15 cm 50 cm...
  • Page 9: Important Information

    • Keep this manual handy as a reference for operating procedures and precautions. • Always keep the volume low enough for outside sounds to be audible. • Protect this product from moisture. In Case of Trouble Should this product fail to operate properly, contact your dealer or nearest authorized PIONEER Service Station.
  • Page 10: Important Safeguard

    ,PSRUWDQW 6DIHJXDUG Please read all of these instructions regarding your display and retain them for future reference ! 1. Read this manual fully and carefully before operating your display. 2. Keep this manual handy for future reference. 3. Pay close attention to all warnings in this manual and follow the instructions carefully. 4.
  • Page 11: Key Finder

    .H\ )LQGHU This Product The following diagram shows the display when it is deployed. Display WIDE button Wide mode indicators ANGLE button Signal Receptor DIM button BRIGHTNESS OPEN/CLOSE button button Release Section RESET button • Use the remote control products for the AUDIO VISUAL MASTER UNIT by pointing them at this product's signal receptor.
  • Page 12: Before Using This Product

    %HIRUH 8VLQJ 7KLV 3URGXFW Be Sure to Adjust Picture Brightness Although the angle at which the LCD can be positioned and viewed clearly is limited because of its design, visibility can be improved by adjusting the pictures brightness. When first using the display, adjust the picture to a brightness that allows clear visibility at the angle of use.
  • Page 13: Operation Of The Display

    2SHUDWLRQ RI WKH 'LVSOD\ CAUTION Do not operate this product while driving your vehicle. Deploying the Display The display will be automatically deployed by the automatic close/open mode. If the display is not automatically deployed, press the OPEN/CLOSE button. • The automatic close/open mode will operate the display as follows. * When the ignition switch is turned OFF while the display is deployed, the display will be closed after approximately 6 seconds.
  • Page 14: Screen Angle Adjustment

    2SHUDWLRQ RI WKH 'LVSOD\ Screen Angle Adjustment The angle of this product’s screen continues changing as long as you keep pressing the ANGLE button. • If you can hear the display knocking against your vehicle's console or dashboard, press the ANGLE button on the (–) side to move the screen a little forward.
  • Page 15: Closing The Display

    Closing the Display The display will be automatically closed by the automatic close/open mode. If the display does not close automatically, press the OPEN/CLOSE button. • When closing the display, check to make sure that it has closed completely. If the display has stopped halfway, leaving it like this could result in damage to it.
  • Page 16: Brightness Adjustment

    2SHUDWLRQ RI WKH 'LVSOD\ Brightness Adjustment The screen’s brightness can be adjusted. (You can make different adjustments for when the vehicle’s inside light is ON or OFF.) • At night, the screen may be too bright because of the surrounding darkness. Turning the vehicle's inside light on will lessen the screen's brightness.
  • Page 17: Changing The Wide Mode

    Changing the Wide Mode You can select a desired mode for enlarging a 4:3 picture to a 16:9 one. Just (JUST) + Full (FULL) + Cinema (CINEMA) + Zoom (ZOOM) + Normal (NORMAL) Just (JUST) The picture is enlarged slightly at the center and the amount of enlargement increases horizontally to the ends, enabling you to enjoy a 4:3 picture without sensing any disparity even on a wide screen.
  • Page 18: Canceling The Automatic Close/Open Mode

    2SHUDWLRQ RI WKH 'LVSOD\ Canceling the Automatic Close/Open Mode To prevent the display from hitting the shift lever of an automatic vehicle when it is in the "P" (park) position, or when you do not wish opening/closing of the display to be carried out automatically, please cancel the automatic close/open mode.
  • Page 19: Switching The Illumination Color

    Switching the Illumination Color This product is equipped with two illumination colors, green and red.You can select the desired illumination color. Hold for 2 seconds Repeat the preceding operation to switch to the previous color.
  • Page 20: The Front Panel

    'HWDFKLQJ DQG 5HSODFLQJ WKH )URQW 3DQHO Theft Protection The front panel of this product is detachable to discourage theft. When the front panel is detached, this product will not be operable as the front panel contains the Signal receptor and OPEN/CLOSE button that are necessary for operation. Detaching the Front Panel The LED indicator will flash while the front panel is being detached.
  • Page 21: Using The Display Correctly

    • If you notice smoke, a strange noise or smell, or any other abnormal signs from the display, turn OFF the power immediately and consult your dealer or the nearest authorized PIONEER Service Station. Using the product in this condition may result in failure of the system.
  • Page 22: About The Liquid Crystal Display (Lcd) Screen

    * When the fluorescent tube reaches the end of its useful life, the screen will be dark and the image will no longer be projected. If this happens, consult your dealer or the nearest authorized PIONEER Service Station.
  • Page 23: Specifications

    6SHFLILFDWLRQV General Display Power source ....14.4 V DC (10.8 - 15.1 V allowable) Screen size/Aspect ratio ......7 inch wide/16:9 Grounding system ........... Negative type (effective display area: 154 × 87 mm) Max. current consumption ........... 2.0 A Pixels ..........336,960 (1,440 × 234) Dimensions Type ......
  • Page 24 PIONEER ELECTRONICS OF CANADA, INC. 300 Allstate Parkway, Markham, Ontario L3R 0P2, Canada TEL: (905) 479-4411 PIONEER ELECTRONICS DE MEXICO, S.A. de C.V. San Lorenzo Num 1009 3er piso Desp. 302 Published by Pioneer Electronic Col. Del Valle, Mexico D.F. C.P. 03100 Corporation.

Table of Contents