Lan Setup - D-Link DIR-505L User Manual

Section 3 - Configuration
This page will allow you to configure the internal network settings of your Repeater.
Device Name:
Enter the Device Name of the AP. It recommended to
change the Device Name if there is more than one D-Link
device within the subnet. You can enter the device name
of the AP into your web browser to access the instead of
IP address for configuration. If you are using the device
name to connect, ensure that your PC and your DIR-505L
are on the same network.
LAN Connection
Select the connector you are using from the drop-down
Type:
menu.
IP Address:
Enter the IP address of the access point. The default IP
address is 192.168.0.50. If you change the IP address,
once you click Apply, you will need to enter the new IP
address in your browser to get back into the configuration
utility.
Subnet Mask:
Enter the Subnet Mask assigned by your ISP.
Default Gateway:
Enter the Gateway assigned by your ISP.
D-Link DIR-505L User Manual

LAN Setup

108