Counters - Electrolux EIDW6405HT - Fully Integrated Dishwasher Service Manual

Electrolux
EFS – Dishwashing Systems Platform
Electrolux Professional

5. COUNTERS

This Parameter Family collects cycle counters and water consumption counters.
For water consumption counters a flow meter must be installed. See
Cnt
Counters
Sym. Parameter Description
CYC
Cycles performed counter.
CYC
symbol and two numbers blink consecutively. The cycle number is
obtained by joining the two numbers. Ex.
10042 cycles executed.
cYc
Cycle counter (resettable).
This counter is similar to
below).
nnc
Water Consumption. [present up to software version 3.12]
3
m
Counts of water consumption.
L
Water Consumption. [present up to software version 3.12]
litres
Counts of water consumption.
The total consumption is given by adding
Lit
Water Consumption: resettable counter. [present up to software version 3.12]
Counts the litres of water and is resettable by user (see
rSt
Reset resettable counters:
To reset put 1 this parameter, switch off and then on again:
will show zero. Note that
(see next parameter,
nCY
Store thousand of cycles after that
Ex. If this parameter is settled to 20,
reach 20.000 cycles.
drn
Drain/Cleaning cycles performed.
CYC
Similar to
rCY
Numbers of cycles that can be made after a regeneration cycle (only for
dishwashers with non-continuous water softener) [See paragraph
regeneration cycle.].
NRE
Regeneration cycle counter (only for water softener dishwasher)
[See paragraph 9.1 resin regeneration cycle / paragraph 9.4 Dishwashers with
incorporated continuous water softener].
GEn
Fig.4.1
USER setting mode
(press for 5s)
CYC
Fig. 4.4
CYCLES
DOC. NO. 5956.446.06
CYC
CYC
but is resettable by user (see
nnc
[m
cYc Lit
and
cYc
is used to count cycles for
nCY
).
CAll
message appears on display.
CAll
message appears when
but counts Cleaning Cycles.
GEn
Fig.4.2
Next Family
010
Fig. 4.5
Thousand.
©Copyright 2005 by Electrolux Professional
Electronic Dishwasher
SERVICE MANUAL
PPL
(calibration parameter) into
Unit
10 042
→ →
means
rSt
parameter
L
3
] and [l] values.
rSt
parameter below).
cYc Lit
and
CAll
message
cYc
9.1 resin
Cnt
Fig. 4.3
Counters Fam.:
ENTER
042
Fig. 4.6
Units.
dPA
section (§ Other Parameters).
Factory
Min Max
Default
-
-
3
[m ]
[l]
[l]
-
-
-
- 20
-
cYc
Fig. 4.7
Next counter.
P.8/88