Clearing Cmos Jumper - Gigabyte GA-6LXSV User Manual

24) J_CLRCMOS (Clearing CMOS Jumper)
Use this jumper to clear the CMOS values (e.g. date information and BIOS configurations) and reset
the CMOS values to factory defaults. To clear the CMOS values, place a jumper cap on the two pins to
temporarily short the two pins or use a metal object like a screwdriver to touch the two pins for a few
seconds.
• Always turn off your computer and unplug the power cord from the power outlet before clearing the CMOS
values.
• After clearing the CMOS values and before turning on your computer, be sure to remove the jumper cap from
the jumper. Failure to do so may cause damage to the motherboard.
• After system restart, go to BIOS Setup Exit menu and load factory defaults (select Load Default Values) or
manually
configure the BIOS settings (refer to Chapter 2, "BIOS Setup," for BIOS configurations).
25/26) J_MEUPDATE/J_HDA_SDO1 (ME Recover Jumpers)
J_HDA_SDO1
J_MEUPDATE
1
1-2 Close: Normal operation (Default setting)
1
2-3 Close: Clear CMOS data
J_MEUPDATE
1-2 Close: Normal operation (Default setting)
1
2-3 Close: ME recovery mode.
1
J_HDA_SDO_1
1-2 Close: ME recovery mode.
1
2-3 Close: Normal operation (Default setting)
1
- 29 - Hardware Installation