Dell XPS /Dimension Gen 5 Owner's Manual page 84

8 Press the retention arm into place, securing the card(s) in the computer.
NOTICE:
the computer cover from closing properly or cause damage to the equipment.
9 Connect any cables that should be attached to the card.
See the documentation for the card for information about the card's cable connections.
NOTICE:
the computer.
10 Close the computer cover, reconnect the computer and devices to electrical outlets, and then
turn them on.
11 If you installed an add-in network adapter and you want to disable the integrated network
adapter:
Enter system setup (see page 127), select Integrated Devices, and then change the
a
setting for Network Interface Card to Off.
Connect the network cable to the add-in network adapter's connectors. Do not connect
b
the network cable to the integrated connector on the back panel.
12 Install any drivers required for the card as described in the card documentation.
Removing a PCI Card
1 Follow the procedures in "Before You Begin" on page 69.
2 Press the lever on the card retention arm and raise the retention arm.
3 If necessary, disconnect any cables connected to the card.
4 Grasp the card by its top corners, and ease it out of its connector.
84
Removing and Installing Parts
alignment bar
alignment guide
filler bracket
Do not route card cables over or behind the cards. Cables routed over the cards can prevent
To connect a network cable, first plug the cable into the network wall jack and then plug it into
retention arm