Removing The Bobbin; Inserting The Bobbin - Bernina 830LE Manual

Removing / Inserting the Bobbin
16
A
B

Removing the Bobbin

► open bobbin cover, the hook system swings to the front
► push the latch in the center of the bobbin to the left, the
bobbin pops out and can be removed

Inserting the Bobbin

► with bobbin markings facing the front, place the bobbin
into the hook and push until it clicks into place
Threading Lower Thread
► pull the thread to the right into slit
spring
► pull thread over thread cutter
► close the bobbin cover slowly, the hook swings back to
the rear
The bobbin thread does not have to be T
brought up as the loose end is just the right br
length to start sewing. le
On Only remove the bobbin if the hook is at
the the end position.
Check the threading path
After threading the hook, hold the mirror under the
swung-out hook unit as shown in the pictures below.
► Position of bobbin thread when threaded for sewing
A, then left under the
B and cut