Connecting An Indoor Antenna; Connecting Cable Tv - Insignia NS-L47Q09-10A User Manual

Insignia 47" LCD TV

Connecting an indoor antenna

To connect an indoor antenna:
1 Turn off your TV and all connected equipment.
2 Connect the included dual-telescoping dipole
antenna to the ANTENNA/CABLE
DIGITAL/ANALOG jack on the back of your TV.
Note
Distance from the transmitting source, a man-made
shelter, or natural atmospheric conditions might
influence the reception, which is not related to
antenna performance.

Connecting cable TV

Your TV has a 75 ohm jack for connecting cable TV.
Some cable TV providers scramble the signals for
"premium" (pay) channels. To view these channels,
you need a converter/descrambler box.
If you do not require a converter/descrambler box,
you can connect your cable TV directly to your TV.
For more information, see "No
converter/descrambler box" on page 9.
If you require a converter/descrambler box, you can
connect your cable TV using an RF switch (not
included). For more information about connecting
a converter/descrambler box, see "With
converter/descrambler box" on page 9 and contact
your cable TV provider.
You can also connect cable TV using an HDMI,
component video, S-Video, or AV connection,
depending on your cable box. For more
information, see "Connecting cable TV via a cable
TV box" on page 9.
No converter/descrambler box
To connect cable TV without a
converter/descrambler box:
1 Connect one end of a 75 ohm cable to the
coaxial jack on the back of your TV.
2 Connect the other end of the cable to the cable
TV wall outlet.
With converter/descrambler box
If your cable box descrambles only some channels
(such as premium channels), you need a two-way
splitter, an RF (A/B) switch, and four lengths of
antenna cable. The two-way splitter and RF switch
are not provided.
To connect cable TV with a
converter/descrambler box:
TV
Connecting cable TV via a cable TV box
1 Connect the incoming cable from the cable wall
2 Depending on the jacks available on the cable
3 If you use a component video, S-Video, or AV
www.insigniaproducts.com
• Use the following illustration as a guide to
connect a converter/descrambler box.
Set the RF switch to the A position to tune to
unscrambled channels using your TV remote
control. Set the RF switch to the B position to
watch scrambled channels using the
converter/descrambler controls.
RF switch
A
B
Out In
Cable converter/descrambler box
jack to the cable-in jack on the cable box.
box, connect a cable from the outgoing jacks on
the cable box to the corresponding jacks on the
back of your TV. The connection can be to the
cable-out, HDMI, component video, S-Video, or
AV jack.
Back of TV
cable, connect an audio cable to the
corresponding jacks on the back of your TV and
on the cable box.
Two-set signal splitter
Cable box
HDMI
Video or S-Video
Component
9