Connecting An Antenna Or Cable Tv (No Box); Connecting A Dvd Or Blu-Ray Player - Insignia NS-42L260A13A User Manual

Insignia 42" LCD TV

Connecting an antenna or cable TV (no box)

To connect an antenna or cable TV (no box):
1 Make sure that your TV's power cord is
unplugged, and all connected equipment is
turned off.
2 Connect a coaxial cable to the ANT/CABLE jack
on the back of your TV and to the antenna or
cable TV wall jack.
Back of TV
3 Plug your TV's power cord into a power outlet,
then turn on your TV.
4 Go through the Setup Wizard on page 20.
Notes
• Use a coaxial cable to eliminate interference and
noise from radio waves.
• Do not bundle the coaxial cable with the power
cord or other cables.
• If the antenna is not installed correctly, contact
qualified service personnel to correct the
problem.
• If the signal level for a channel is weak, the
picture may be distorted. Adjust the antenna or
use a highly directional outdoor or set-top
antenna with a built-in amplifier.
• If the picture quality is good on some channels
and poor on others, the problem may be caused
by a poor or weak signal from the broadcaster
or cable TV provider.
• If you connect to cable or satellite TV without a
set-top box and experience poor picture quality,
you may need to install a set-top box to improve
signal reception and picture quality. Contact
your cable or satellite TV provider about
upgrading to a set-top box.
• Many high-definition (HD) channels upscale
standard-definition (SD) content. The picture
displayed on your TV is still displayed as SD, thus
the picture quality will not be as clear or crisp as
it would be if the content was originally
recorded in HD.

Connecting a DVD or Blu-ray player

Using HDMI (best)
Antenna or
cable TV (no box)
Coaxial cable
www.insigniaproducts.com
To connect a DVD or Blu-ray player using HDMI:
1 Make sure that your TV's power cord is
unplugged and the DVD or Blu-ray player is
turned off.
2 Connect an HDMI cable (not provided) to one of
the HDMI jacks on the side of your TV and to the
HDMI OUT jack on the DVD or Blu-ray player.
Side of TV
3 Plug your TV's power cord into a power outlet,
then turn on your TV.
4 Turn on the DVD or Blu-ray player, then set it to
the correct output mode. For more information,
see the documentation that came with the
player.
5 Press INPUT to open the Input Source list.
6 Press or to highlight HDMI 1, HDMI 2, or
HDMI 3, then press ENTER.
Note
You can also press HDMI repeatedly to select the
DVD or Blu-ray player.
DVD or Blu-ray player
13